Depot in the design of the vehicle, Nissan Ignition Coils often because of the design and cost considerations, and in a range of security clearance to sacrifice some part of the vehicle body rigidity, it may be difficult for the average car owners perceive that which is different, but for the modification, the reinforcement for strengthening the body in order to create better control, thus strengthening the body parts "trolley" will be born out. Body rod called "StrutBar" direct translation is "strut", "pillar" means, in simple terms is to increase the support force things. In common "sedan" designed RV, it can be simply divided into the engine compartment, passenger compartment and the luggage compartment, the three "mouth-shaped" structure is not too much lateral connections between the left and right B-pillar and the like lateral luggage compartment, etc., G high-speed cornering force will cause a little twisted sheet metal parts, will allow motorists "not solid" feel, use both sides of the sheet metal parts connecting rod or beam body structure to enhance the hardness, but also increase the lateral support force.
Mainly installed between the engine compartment rod front shock absorber tower, the same is to improve body rigidity.
In addition there are a number of activities will be combined with parts (lower side shock tower, tripod and the rear trailing arm, etc.) and body sheet metal parts, vehicles traveling between parts of these activities will continue to be "left pull" or "strike down" car station and sheet member, naturally increases the chances of deformation, the use of lever or a lever fitted structure can effectively disperse stress and improve the mechanical strength of the activity to suppress the deformation or the displacement of the phenomenon. Therefore, the so-called reinforcing rod is rigid vehicle conversion kits, but the body itself have a certain level of strength, not everyone has a clear feeling after installation.
In addition there are a number of activities will be combined with parts (lower side shock tower, tripod and the rear trailing arm, etc.) and body sheet metal parts, vehicles traveling between parts of these activities will continue to be "left pull" or "strike down" car station and sheet member, naturally increases the chances of deformation, the use of lever or a lever fitted structure can effectively disperse stress and improve the mechanical strength of the activity to suppress the deformation or the displacement of the phenomenon. Therefore, the so-called reinforcing rod is rigid vehicle conversion kits, but the body itself have a certain level of strength, not everyone has a clear feeling after installation.
Many readers will be deemed to be anti-roll bar is a lever, the role of fact, anti-roll bar is relatively similar to the shock absorber spring, not to be confused with the body lever.
The rod can be divided into the engine compartment rod, hanging on the rod, B / C pillar after luggage trolley, etc., but with the most relevant manipulative lever or chassis structure is more important, this type of rod mostly have a very special , installation location will be right and left sides of the "E46 camber arms", say juncture tripod bush, after trailing arm and girders, which are about the mechanical actuation independent, non-stop between the vehicle left and right and up and down to pull actuation, by actuating rod connecting the two separate parts, in order to increase driving stability, better to avoid the displacement of the movable parts to extend the life of mechanical activity.
The rod can be divided into the engine compartment rod, hanging on the rod, B / C pillar after luggage trolley, etc., but with the most relevant manipulative lever or chassis structure is more important, this type of rod mostly have a very special , installation location will be right and left sides of the "E46 camber arms", say juncture tripod bush, after trailing arm and girders, which are about the mechanical actuation independent, non-stop between the vehicle left and right and up and down to pull actuation, by actuating rod connecting the two separate parts, in order to increase driving stability, better to avoid the displacement of the movable parts to extend the life of mechanical activity.
没有评论:
发表评论